Switching Remotes during a live performance

You can swap a Remote mid-set without stopping the music. Here is how to do it cleanly.

Why you might need this

If a Remote runs out of battery during a performance, or you want to hand off a deck to another DJ, you can link a fresh Remote to the Receiver while the set is running.

How to switch a Remote

1. Place the new (charged) Remote into the dock of the deck you want to reassign (A or B).
2. Long-press the corresponding A or B setup button for 3 seconds to link the new Remote.
3. The previously linked Remote will flash red briefly and turn white, indicating it has been disconnected from that deck.
4. Take the new Remote out of the dock and place it on the turntable. Wait for the LED to turn solid (calibration complete) before spinning.
   
   

Tips for a clean swap

• Have the replacement Remote fully charged before the set.
• The swap itself takes about 5 seconds. The calibration after placement takes a few more seconds.
• In DVS mode, the deck will continue playing from the Receiver's output during the swap. In HID mode, the deck may briefly lose control until the new Remote finishes calibrating.
• If you are on a 2-turntable setup, you can only spin the deck with the active Remote. During the calibration of the new Remote, keep that platter still.
  
  

FAQ

Can I swap both Remotes at the same time?

You can, but it is not recommended during a live set. Swap one at a time to avoid losing control of both decks simultaneously.

Does the new Remote inherit the deck assignment of the previous one?

Yes. Linking to dock A assigns the new Remote to deck A, same as before.

Hitting a wall?
The Phase team is one ticket away.